When the tile press machine is working normally, there will be burrs on the cutting board. Khi máy ép gạch hoạt động bình thường, sẽ có các vệt trên thớt. This is a frequent failure, so how to solve this problem? Đây là một thất bại thường xuyên, vậy làm thế nào để giải quyết vấn đề này?
1. First check whether the screws of the slide rail clamps are loose. 1. Trước tiên hãy kiểm tra xem các ốc vít của kẹp ray trượt có bị lỏng không. If loose, tighten them to feel firm and hard. Nếu lỏng, hãy thắt chặt chúng để cảm thấy cứng và cứng.
2. Loosen the oil pressure to a minimum. 2. Nới lỏng áp suất dầu đến mức tối thiểu. Loosen the oil pressure adjustment screw outward. Nới lỏng vít điều chỉnh áp suất dầu ra bên ngoài.
3. Choose manual, jog the knife to drop, make the upper and lower knife overlap about half a centimeter. 3. Chọn thủ công, chạy dao để thả, làm cho dao trên và dưới chồng lên nhau khoảng nửa centimet. If the cutter does not move, adjust the oil pressure appropriately. Nếu dao cắt không di chuyển, điều chỉnh áp suất dầu phù hợp. Loosen the external adjustment screw of the bottom knife, tighten the back adjustment screw, and tighten the external adjustment screw. Nới lỏng vít điều chỉnh bên ngoài của dao đáy, siết vít điều chỉnh phía sau và siết vít điều chỉnh bên ngoài. Jog the cutter to rise. Chạy bộ cắt để tăng. If you hear a "bang", it proves that the adjustment is too much or uneven. Nếu bạn nghe thấy tiếng "nổ", điều đó chứng tỏ rằng sự điều chỉnh quá nhiều hoặc không đồng đều. The bottom knife should be adjusted inwards first, and the upper knife should be dropped and readjusted. Dao dưới cùng nên được điều chỉnh vào trong trước, và dao trên nên được bỏ và điều chỉnh lại. After adjustment, first use a small piece of board to test the knife. Sau khi điều chỉnh, đầu tiên sử dụng một miếng ván nhỏ để thử dao.
4. Điều chỉnh máy cắt là một công việc cẩn thận và đòi hỏi sự kiên nhẫn.
Người liên hệ: Mr. Arno Hao
Tel: +8618717894416